Switching A Voice/Videophone Call During A Call - NTT docomo STYLE Series Instruction Manual

When the Videophone call does not connect
When the Videophone call does not connect, a message explaining
the reason appears. The other party's actual conditions may vary
depending on the type of phone and network service subscriptions.
[Check number, then redial]: A call is made to unused phone
number.
[Busy]: The other party is engaged in a call (This message may
appear during a packet transmission depending on the other
party's terminal).
[Your call is being forwarded]: The other party's handset is set
to forward Videophone calls.
[Out of service area/power off]: The other party is outside the
service area, or their mobile phone is turned off.
[Set caller ID to on]: Connected without notifying the caller ID
(when calling the visualnet, etc.).
[Redial using voice call]: The other party's handset is set to the
Call Forwarding Service and the forwarding destination does
not support Videophone.
[Busy with packet transmission]: The other party is performing a
packet transmission.
[Upper limit has been exceeded. Connection failed]: Upper limit
set by payment plans with limit function (Type Limit or Family
Wide Limit) has been exceeded.
[Please make your call from the i-mode web page]: A Videophone
call is directly made to the V-live which should be accessed after
connecting to i-mode. Access a site run by the contents provider
and view it by making a Videophone call from the link.
[Connection failed]: Appears in cases other than those any
reasons.
Hands-free
For precautions on using Hands-free nP. 70
Hands-free is available while making a voice call or calling. Not
available while receiving a call.
Hands-free is disabled when a call ends.
50
■ Placing calls on hold
<Hold Active Call>
1
During a call, press C/[Hold Active Call].
: Alternatively, press t during a Videophone call.
2
To resume a call, press s.
: Alternatively, press C during a voice call.
: Press i during a Videophone call to resume with a substitute
image.
The other party hears the hold tone, and the call is placed on hold.
For Videophone calls, the image set in Hold image is sent to the
other party with [Hold] superimposed.
Calls stay on hold even when the FOMA terminal is closed. Set
when folded does not apply.
Switching a voice/Videophone call
during a call
Switch between a voice call and a Videophone for placed calls.
The Notify switch mode (nP. 71) must be set to "Activate" for the
other party's FOMA terminal.
Received calls cannot be switched. Have the other party switch.
1
During a call, press C/[Switch to v.phone]/[chg
to voice call]/[Yes].
: Alternatively, press a to switch.
: Switching takes approximately 5 seconds. Switching may take
more time depending on the signal status. [Please wait for a
while] appears and a guidance message is played.