Making A Voice/Videophone Call - NTT docomo STYLE Series Instruction Manual

8Hands-free icon
5
Hands-free in progress
(red)
6
(green) USB hands-free in progress
9Earpiece volume icon
.
v (Volume 1) to @ (Volume 10)
The display brightness during a Videophone call follows the
setting of the Original Eco mode in Light/Power saver.

Making a voice/Videophone call

Calls may be interrupted even when the signal is strong (]
appears) and you are not moving.
To call selecting a Multi Number nP. 381
To call selecting a phone number when the 2in1 is used nP. 382
1
In stand-by, enter a phone
number.
: Always enter the area code even when the
number is in the same area.
: Enter up to 80 digits.
: To erase the last digit: Press c.
: To erase all digits: Press c (for 1+
seconds).
2
Press s (Phone)/i (V.phone).
: Unlike ordinary telephones, mobile phones send call tones in
short beeps before the standard ring tone.
: When the other party is busy, there is a busy signal. Disconnect
and try again later.
Operation during a voice call
: To add to the phonebook: Press C/[Add to phonebook]/add
to the phonebook.
: To display your own phone number: Press C/[Own number].
: To enable/disable Hands-free: Press s (for 1+ seconds).
Operation during a Videophone call
: To display your own phone number: Press C/[Own number].
: To enable/disable Hands-free: Press s.
: To switch between a substitute image and My side: Press i.
3
Press H to end the call.
When the 2in1 mode is set to [Dual mode], the screen for selecting
a phone number appears after step 2. Select the phone number
from [Number A] or [Number B].
Voice calls
Calls can be made even when steps 1 and 2 are reversed. If no
operations are performed for approximately 5 seconds after
entering the phone number, the call is made.
Videophone calls
A Videophone call is not connected when placed to an
unsupported handset. In addition, it is not connected to devices for
which 64K cannot be used due to network conditions.
If Call Waiting is subscribed to, the number is recorded in
Received calls and the stock icon B (missed call) appears when
a voice/Videophone call is received during a Videophone call.
When the sending/receiving of audio or video fails, the
Videophone call is not automatically restored. Make the
Videophone call again.
Continued on next page
49