NTT docomo STYLE Series Instruction Manual page 96

Light duration is prioritized as follows when it is set multiply.
i-appli b Videophone/Internet b Charging b Normal
Light
duration
• If Videophone is used while i-appli is being activated, Display
light time for Videophone is prioritized.
• When Charging is set to [Always ON] and Videophone is used
while charging, Display light time is set to [Always ON]
regardless of the setting for Videophone.
Setting Screen display time
Turn off the display when the FOMA terminal is not in use for a set
length of time.
1
In the Custom menu, select [Settings]/[Disp/LED/
Power saver]/[Light/Power saver]/[Original Eco
mode]/[Screen dsp time].
2
Select the time/t.
When the display is turned off, press a key to show the screen.
During i-Channel ticker playback, the display is turned off
according to the screen display time setting. However, when the
Screen display time is set to [30 seconds], the display remains for
approximately 60 seconds.
94
Priority (high b low)
<Screen dsp time>
The display is not turned off even when the Screen display time
passes in the following cases.
Videophone calls are in progress
i-mode transmission is in progress
Mail is being sent/received
*1
i-motion is being played
GPS positioning is being performed
Data is being transferred with an external device
1Seg is being watched/recorded
Video is being played *2
Auto channel setting for 1Seg is being set
*1 Excluding Stand-by i-motion.
*2 Except when using Multi Window.
Adjusting display brightness
Adjusting methods are as follows.
Automatic Adjust the display brightness automatically according
to the surrounding light. Keypad light is automatically
switched between Light and OFF when Keypad light
setting is set to [Light].
Manual Select from 16 display brightness levels. Check the
brightness while adjusting it.
1
In the Custom menu, select [Settings]/[Disp/LED/
Power saver]/[Light/Power saver]/[Original Eco
mode]/[Brightness].
2
Select the adjusting method/t.
: When in [Manual]: Select [Manual]/adjust the brightness with
u/t.
Note that increasing the brightness shortens the continuous
stand-by time.
Camera is being activated
Slideshow is being played
*2
PC movie is being played
<Brightness>