Setting I-Mode - NTT docomo STYLE Series Instruction Manual

Setting i-mode

Set various functions relating to i-mode access.
Changing hosts from i-mode (ISP connection
transmission)
<Host selection>
Settings do not need to be changed to use i-mode.
ISP connection transmission
■
When changing the FOMA terminal host, connect to various providers
(ISP). A subscription to the Packet Transmission Service is required to
use the ISP connection transmission. Packet transmission charges
apply for the ISP connection transmission.
A subscription is not required for i-mode subscribers.
Pake-hodai/Pake-hodai full/Pake-hodai double does not apply to
packet transmission incurred for hosts other than DOCOMO.
Provider agreements
■
A subscription to another provider is required for the ISP connection
transmission. Contact providers for details regarding service
contents (site/Internet access, mail, etc.) and subscription
procedures.
Some services may require a separate fee.
Phone number and location information may be sent to the provider
depending on the site.
Save up to ten hosts in the FOMA terminal handset (excluding
[i-mode (UIM)]).
i-mode is not available when hosts other than [i-mode (UIM)] are
used.
■ Saving hosts
1
In stand-by, press i/[i-mode setting]/[Host
selection].
2
Select a number to save/t/[Edit].
3
Enter the terminal security code/t.
4
Enter the host name/t.
: [Host A] appears when a new host is saved. The host number
selected in step 2 appears for A.
: Enter up to 16 single-byte (8 double-byte) characters.
5
Enter the host number/t.
: Enter up to 99 single-byte characters (alphanumeric characters
and symbols).
6
Enter the host address/t.
: Enter up to 30 single-byte characters (alphanumeric characters
and symbols).
7
Enter the host address for i-Channel/t.
: Enter up to 30 single-byte characters (alphanumeric characters
and symbols).
■ Changing hosts
1
In stand-by, press i/[i-mode setting]/[Host
selection].
2
Select a host number/t/[Set].
Resetting saved contents
■
When saved hosts are reset, the host is set to [i-mode (UIM)].
1
In stand-by, press i/[i-mode setting]/[Host
selection]/select a host number/t/[Reset].
2
Enter the terminal security code/t.
<Reset>
167