NTT docomo STYLE Series Instruction Manual page 97

Setting keypad backlight
Set whether to turn on or off the keypad backlight.
1
In the Custom menu, select [Settings]/[Disp/LED/
Power saver]/[Light/Power saver]/[Original Eco
mode]/[Keypad light setting].
2
Select the setting/t.
The duration when set to [Light] follows the Display light time
setting.
Note that setting to [Light] shortens the continuous stand-by time.
Kisekae Tool
Changing display of Custom menu
Use the Kisekae Tool to change the Custom menu screen,
stand-by display, menu icon, ring tone, etc. collectively.
For details on downloading the Kisekae Tool nP. 164
The following items can be set. However, items that can be
changed depend on the set Kisekae Tool.
Screen Stand-by display, Outgoing voice calls, Videophone
sending screen, Incoming voice calls display, Incoming
video phone display, Send display, Receive display, Mail
received display, Signal icon, Battery icon, Animate
notices, Custom menu image (including i-mode menu
image and mail menu image), Machi-chara
Ring Phone ring tone, Videophone ring tone, Mail ring tone,
tone MessageR ring tone, MessageF ring tone
Other Color theme, Font size
1
In the Custom menu, select [Data box]/[Kisekae
Tool].
: Alternatively, press i in the Custom menu or Basic menu.
<Keypad light setting>
2
Select Kisekae Tool/i/[Yes].
: To check data: Select Kisekae Tool/t (to show data list
screen)/select data/t.
: In the confirmation screen for the collective setting of the font
size, select [Yes] to change to the font size specified for Kisekae
Tool.
When the Custom menu image is changed by Kisekae Tool, some
items in the Custom menu may be changed according to the menu
history. In addition, some items cannot be selected even if the
function number is entered. In this case, the operation may not run
as explained in this manual. Switch the menu screen to the Basic
menu (nP. 32) or perform Reset menu screen (nP. 96).
Checking Kisekae Tool saved in the [Movable contents] folder on
the microSD Card is possible. However, they cannot be directly
set. Transfer them to the FOMA terminal handset before setting.
Even if Kisekae Tool is set in each mode while the 2in1 service is
set, items other than the following are reflected to all modes/phone
numbers/mail addresses.
The stand-by display is reflected to only A mode.
Phone ring tone and V.phone ring tone are reflected to only
Number A.
Mail ring tone is reflected to only Address A.
■ Adjusting data check volume
1
In the data list screen, press C/[Set volume].
2
Adjust the volume with u/t.
Setting display size when setting i-motion as
■
stand-by
<Stand-by i-motion>
1
In the data list screen, press C/[Stand-by
i-motion].
2
Select the size/t.
<Set volume>
95