NTT docomo STYLE Series Instruction Manual page 260

Setting item
DCMX credit appli
i-appli banking
McDonald's TOKUSURU
KEITAI application
Mobile Suica Setup i-appli
Packet transmission charges apply when this service is used.
Precautions for Osaifu-Keitai compatible i-appli
DOCOMO shall not be liable for the information set in the IC card.
Auto start
Running i-appli automatically
There are three methods to automatically start i-appli.
Auto start using the Set Auto start to [ON] to enable.
i-appliDX setting
Auto start using the Auto start setting pre-installed in software. Set
software function Auto start to [ON] and register software to
enable. Register up to nine.
Auto start using the Set time, date and day for i-appli saved in the
FOMA terminal FOMA terminal to set Auto start. Set Auto start
setting to [ON] and set a schedule to use. Register up
to nine.
Set the correct date and time in advance (nP. 44).
258
Default setting
Network set: Yes
i-appli To: Yes
Network set: Yes
i-appli To: Yes
Network set: Yes
i-appli To: Yes
Network set: Yes
i-appli To: Yes
Starting automatically
1
In the Custom menu, select [i-appli]/[Auto start].
2
Select the setting/t.
If Auto start cannot be started, the error is recorded in the Auto
start error history (only when the handset is turned on).
Automatic startup is not available in the following situations.
Handset is turned off
Other functions are activated
When Auto start and Alarm (Alarm/Schedule/Reception/
Recording) are set for the same time
Function lock is applied to i-appli
Mail-type i-appli is set to start automatically when the 2in1
mode is set to [B mode]
FOMA card is not inserted
FOMA card inserted is different from the one that was used
when the appli with Auto start was downloaded
The functions below operate with the following priority when the
same time is set.
Priority (high b low)
Function Auto power OFF b Auto power ON b Alarm b
i-appli Auto start
Reset settings deletes the auto start error history and disables the
i-appli Auto start settings.
If the transmission setting for software with Auto start settings is
set to [Always confirm], a transmission confirmation screen
appears upon startup. If no operations are performed for
approximately 5 seconds, software starts automatically as if [No]
was selected in the confirmation screen.
When two Auto start times for the same software are set within 9
minutes of each other, Auto start does not function. Set Auto start
time interval to 10 minutes or more. [Run error] appears in the
Auto start error history.
<Auto start>
i-appli is running
Call is in progress