Main Menu - Drive Information - Group - Danfoss VLT DriveMotor FCP 106 Programming Manual

Parameters

4.12 Main Menu - Drive Information - Group

15
Parameter group containing frequency converter
information such as operating data, hardware configu-
ration, and software versions.
4.12.1 15-0* Operating Data
15-00 Operating hours
Range: Function:
0 h [0 - 0x7fffffff. h] View how many hours the frequency
*
converter has run. The value is saved
when the frequency converter is turned
off.
15-01 Running Hours
Range: Function:
0 h [0 - View how many hours the motor has run.
*
0x7fffffff. h] Reset the counter in parameter 15-07 Reset
Running Hours Counter. The value is saved
when the frequency converter is turned off.
15-02 kWh Counter
Range: Function:
0 kWh [0 - View the output power of the
*
2147483647 frequency converter in kWh as an
kWh] average value over 1 hour. Reset the
counter in parameter 15-06 Reset kWh
Counter.
15-03 Power Up's
Range: Function:
0 [0 - 2147483647 ] View the number of times the frequency
*
converter has been powered up.
15-04 Over Temp's
Range: Function:
0 [0 - 65535 ] View the number of frequency converter
*
temperature faults that have occurred.
15-05 Over Volt's
Range: Function:
0 [0 - 65535 ] View the number of frequency converter
*
overvoltages that have occurred.
15-06 Reset kWh Counter
Option: Function:
NOTICE
To reset, press [OK] .
[0] Do not reset
*
MG03N202
Programming Guide
15-06 Reset kWh Counter
Option:
[1] Reset counter To reset the kWh counter to 0, select [1]
15-07 Reset Running Hours Counter
Option:
[0] Do not
*
reset
[1] Reset
counter
4.12.2 15-3* Alarm Log
Parameters in this group are array parameters, where up to
10 fault logs can be viewed. [0] is the most recent logged
data, and [9] the oldest. Fault codes, values, and time
stamp can be viewed for all logged data.
15-30 Alarm Log: Error Code
Range:
0 [0 - 255 ] View the fault code and look up its meaning in
*
15-31 InternalFaultReason
Range:
0 [-32767 - 32767 ] View a description of the error. This
*
4.12.3 15-4* Drive Identification
Parameters containing read-only information about the
hardware and software configuration of the frequency
converter.
15-40 FC Type
Range:
0 [0 - 6 ] View the FC type code. The readout is identical to
*
15-41 Power Section
Range:
0 [0 - 20 ] View the FC type code. The readout is identical to
*
Danfoss A/S © 11/2015 All rights reserved.
Function:
Reset and press [OK] (see
parameter 15-02 kWh Counter).
Function:
To reset the running hours counter to 0, select
[1] Reset and press [OK] (see
parameter 15-01 Running Hours). This
parameter cannot be selected via the serial
port, RS485.
Select [0] Do not reset if no reset of the
running-hours counter is required.
Function:
chapter 5 Diagnostics and Troubleshooting.
Function:
parameter is used with alarm 38, Internal
fault.
Function:
the frequency converter series power field of the
type code definition, characters 1–6.
Function:
the frequency converter series power field of the
type code definition, characters 7–10.
4 4
93