Danfoss VLT DriveMotor FCP 106 Programming Manual page 40

Parameters
0-30 Custom Readout Unit
Option:
[0] None
[1] %
*
[5] PPM
4 4 [10] l/Min
[11] RPM
[12] Pulse/s
[20] l/s
[21] l/min
[22] l/h
[23] m3/s
[24] m3/min
[25] m3/h
[30] kg/s
[31] kg/min
[32] kg/h
[33] t/min
[34] t/h
[40] m/s
[41] m/min
[45] m
[60] Degree Celsius
[70] mbar
[71] bar
[72] Pa
[73] kPa
[74] m Wg
[80] kW
[120] GPM
[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[127] ft3/h
[140] ft/s
[141] ft/min
[160] Degree Fahr
[170] psi
[171] lb/in2
[172] in WG
[173] ft WG
[180] hp
0-31 Custom Readout Min Value
Range:
0 CustomRea-
doutUnit
*
38
VLT
Function:
be read in parameter 16-09 Custom
Readout.
Function:
[ 0 - This parameter sets the
999999.99 minimum value of the custom-
CustomRea- defined readout (occurs at 0
doutUnit] speed). It is only possible to
select a value different from 0
when selecting a linear unit in
Danfoss A/S © 11/2015 All rights reserved.
®
DriveMotor FCP 106/FCM 106
0-31 Custom Readout Min Value
Range:
0-32 Custom Readout Max Value
Range:
100 Custom-
ReadoutUnit
0-37 Display Text 1
Range:
[0 - 0 ] Use this parameter to write an individual text string
0-38 Display Text 2
Range:
[0 - 0 ] Use this parameter to write an individual text string
0-39 Display Text 3
Range:
[0 - 0 ] Use this parameter to write an individual text string
4.1.4 0-4* LCP
Enable, disable, and password protect individual keys on
the LCP.
0-40 [Hand on] Key on LCP
Option:
[0] Disabled To avoid unintended start of the frequency
[1] Enabled [Hand On] is enabled.
*
0-42 [Auto on] Key on LCP
Option:
[0] Disabled To avoid unintended start of the frequency
[1] Enabled [Auto On] is enabled.
*
Function:
parameter 0-30 Custom Readout
Unit. For quadratic and cubic
units, the minimum value is 0.
Function:
[ 0.0 - This parameter sets the
999999.99 maximum value to be shown
*
CustomRea- when the speed of the motor
doutUnit] has reached the set value for
parameter 4-14 Motor Speed
High Limit [Hz].
Function:
to be read via serial communication. Device ID can
be included.
Only used when running BACnet.
Function:
to be read via serial communication.
Only used when running BACnet.
Function:
to be read via serial communication.
Only used when running BACnet.
Function:
converter in local mode, select [0] Disabled.
Function:
converter from the LCP, select [0] Disabled.
MG03N202