Danfoss VLT DriveMotor FCP 106 Programming Manual page 82

Parameters
9-63 Actual Baud Rate
Option:
[11] 45,45 kbit/s
[255] No baudrate found
*
9-64 Device Identification
Range:
NOTICE
0 [0 -
*
4 4
0 ]
This parameter is not visible via LCP.
The device identification parameter. The data type
is array[n] of unsigned16. The assignment of the
first subindexes is defined and shown in Table 4.8.
9-65 Profile Number
Range:
0 [0 - 0 ]
*
9-67 Control Word 1
Range:
0 [0 - 65535 ] This parameter accepts the control word from a
*
9-68 Status Word 1
Range:
0 [0 - 65535 ] This parameter delivers the status word for a
*
80
Function:
Function:
Index Content Value
0 Manufacturer 128
1 Device type 1
2 Version xxyy
3 Firmware date year yyyy
4 Firmware date ddmm
month
5 No. of axes Variable
6 Vendor specific: PB xxyy
Version
7 Vendor specific: xxyy
Database Version
8 Vendor specific: xxyy
AOC Version
9 Vendor specific: xxyy
MOC Version
Function:
NOTICE
This parameter is not visible via LCP.
This parameter contains the profile identification.
Byte 1 contains the profile number and byte 2 the
version number of the profile.
Function:
master class 2 in the same format as PCD 1.
Function:
master class 2 in the same format as PCD 2.
Danfoss A/S © 11/2015 All rights reserved.
®
VLT DriveMotor FCP 106/FCM 106
9-70 Edit Set-up
Option:
[1] Set-up 1
[2] Set-up 2
[9] Active Set-
*
up
9-71 Profibus Save Data Values
Option:
[0] Off
*
[1] Store all
setups
[2] Store all
setups
9-72 ProfibusDriveReset
Option:
[0] No action
*
[1] Power-on reset
[2] Power-on reset
prep
[3] Comm option
reset
9-75 DO Identification
Range:
0 [0 - 65535 ] Provides information about the DO (drive
*
Function:
Select the set-up in which programming
(change of data) is performed during operation.
It is possible to program the 4 set-ups
independently of the set-up selected as active
set-up. Parameter access from each master is
directed to the set-up selected by the
individual master (cyclic, acyclic MCL1, 1st
acyclic MCL2, 2nd acyclic MCL2, 3rd acyclic
MCL2).
Function:
Parameter values changed via RS485 are not
automatically stored in a non-volatile memory.
Use this parameter to activate a function that
stores parameter values in the EEPROM non-
volatile memory, so changed parameter values
are retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values in the set-up selected
in parameter 9-70 Edit Set-up in the non-volatile
memory. The selection returns to [0] Off when all
values are stored.
Stores all parameter values for all set-ups in the
non-volatile memory. The selection returns to [0]
Off when all parameter values are stored.
Function:
NOTICE
®
Resets the VLT PROFIBUS DP MCA
101 option only.
Resets frequency converter after power-
up, as for power cycle.
When reset, the frequency converter
disappears from the fieldbus, which may
cause a communication error from the
master.
Function:
object).
MG03N202