Danfoss VLT DriveMotor FCP 106 Programming Manual page 85

Parameters
13-01 Start Event
Option: Function:
[26] Logic rule 0 Use the result of logic rule 0 in the logic
rule.
[27] Logic rule 1 Use the result of logic rule 1 in the logic
rule.
[28] Logic rule 2 Use the result of logic rule 2 in the logic
rule.
[29] Logic rule 3 Use the result of logic rule 3 in the logic
rule.
[33] Digital input Use the value of DI18 in the logic rule
DI18 (High=true).
[34] Digital input Use the value of DI19 in the logic rule
DI19 (High=true).
[35] Digital input Use the value of DI27 in the logic rule
DI27 (High=true).
[36] Digital input Use the value of DI29 in the logic rule
DI29 (High=true).
[39] Start This event is true if the frequency
command converter is started (either via digital
*
input, fieldbus or other).
[40] Drive stopped This event is true if the frequency
converter is stopped or coasted (either via
digital input, fieldbus, or other).
[42] Auto Reset This event is true if the frequency
Trip converter is tripped (but not trip-locked)
and an automatic reset is issued.
[50] Comparator 4 Use the result of comparator 4 in the logic
rule.
[51] Comparator 5 Use the result of comparator 5 in the logic
rule.
[60] Logic rule 4 Use the result of logic rule 4 in the logic
rule.
[61] Logic rule 5 Use the result of logic rule 5 in the logic
rule.
[83] Broken Belt A broken-belt condition is detected.
Enable this function in
parameter 22-60 Broken Belt Function.
13-02 Stop Event
Option: Function:
Select the condition (true or false)
which deactivates the smart logic
controller.
[0] False
[1] True
[2] Running
[3] In range
[4] On reference
[7] Out of current range
MG03N202
Programming Guide
13-02 Stop Event
Option:
[8] Below I low
[9] Above I high
[16] Thermal warning
[17] Mains out of range
[18] Reversing
[19] Warning
[20] Alarm (trip)
[21] Alarm (trip lock)
[22] Comparator 0
[23] Comparator 1
[24] Comparator 2
[25] Comparator 3
[26] Logic rule 0
[27] Logic rule 1
[28] Logic rule 2
[29] Logic rule 3
[30] SL Time-out 0
[31] SL Time-out 1
[32] SL Time-out 2
[33] Digital input DI18
[34] Digital input DI19
[35] Digital input DI27
[36] Digital input DI29
[39] Start command
[40] Drive stopped
*
[42] Auto Reset Trip
[50] Comparator 4
[51] Comparator 5
[60] Logic rule 4
[61] Logic rule 5
[70] SL Time-out 3
[71] SL Time-out 4
[72] SL Time-out 5
[73] SL Time-out 6
[74] SL Time-out 7
[81] Dry Pump
[82] End of Curve
[83] Broken Belt
13-03 Reset SLC
Option:
[0] Do not reset
*
SLC
[1] Reset SLC
Danfoss A/S © 11/2015 All rights reserved.
Function:
Function:
Retains programmed settings in all group
13 parameters (13-** Smart Logic).
Resets all group 13 parameters (13-** Smart
Logic) to default settings.
4 4
83