Displays And Controls - Pepperl+Fuchs IDENTControl IC-KP2-2HB18-2V1 Manual

IC-KP2-2HB18-2V1
Product Description
4.7

Displays and controls

Figure 4.7
LEDs
Description
1
2
CH1
CH2
PWR/ERR
L RUN
L ERR
L RUN
Lights up
green
Lights up
green
Lights up
green
Off
14
1
CH1 CH1
PWR/ERR
L ERR
L RUN
Function
Status display for
R/W heads
Indicates that a
R/W head is
connected
Status display for
IDENTControl
Compact
see table below
L ERR
Flashes red
Flashes red with
0.4 s interval
Off
Flashes red
2
Extended
cyclic
setting
CH2 CH2
Status description
LED lights up green when there is an active
command on the R/W head.
LED lights up yellow for approx. 1 second when a
command is executed successfully.
LED lights up green when a R/W head is connected
to channel 1 or channel 2.
LED lights up red when a configuration error occurs.
LED lights up green when the IDENTControl
Compact is connected to a power supply and the
interface is ready for operation.
LED lights up red if a hardware fault occurs.
Status description
Communication available, but some cyclic
■
redundancy check errors
No response, as the data received causes a cyclic
■
redundancy check error
The baud rate or station no. was changed since last
start or restart.
Normal communication.
■
No data for the controller.
■
Data for the controller causes a cyclic redundancy
1)
check error .
Station no.
x1
Station no.
x10
Baud rate
1)
due to noise.
1)
.