Non-Volatile Parameters - Pepperl+Fuchs IDENTControl IC-KP2-2HB18-2V1 Manual

Compact control interface with interface for cc-link v2

Hide thumbs Also See for IDENTControl IC-KP2-2HB18-2V1:

Table of Contents

IC-KP2-2HB18-2V1

Commissioning

6.2.4

Non-volatile parameters

There are volatile and non-volatile parameters. Volatile parameters are reset to

their default setting when the system is switched off and on again.

Non-volatile parameters

Parameter

General

Multiplex mode

R/W head

Trigger mode

Tag type

Configure the non-volatile parameters of the R/W system with the described

system commands (see chapter 7.3.7). The "multiplex mode" and "tag type"

parameters can also be set via initial settings. "99" is preset as the tag type.

Default setting

Off

Value range

On / off

00 ... FF

Table of Contents

Do you have a question about the IDENTControl IC-KP2-2HB18-2V1 and is the answer not in the manual?