Command Overview - Pepperl+Fuchs IDENTControl IC-KP2-2HB18-2V1 Manual

IC-KP2-2HB18-2V1
Commands
Troubleshooting, RYn4 as confirmation
Figure 7.13
7.3.7

Command overview

The commands in the list are described in detail on the following pages.
System commands
Command
code
4d
2d
23d
22d
180d
155d
172d
156d
Standard read/write commands
Read only code
Command
code
1d
29d
44
ID command execution request (RYn4)
ID BUSY (RXn3)
ID division data request (RXn7)
ID division data complete (RYn7)
ID command complete (RXn4)
ID data ack (RYn3)
ID in zone contact (RXn2)
ID error occurrence (RXn5) Tag communication
Command description
04h See "Change tag (CT --> 04h)" on page 46
02h See "Quit (QU --> 02h)" on page 49
17h See "Configuration store (CS --> 17h)" on page 49
16h See "Reset (RS --> 16h)" on page 50
B4h See "Reset to default (RD --> B4h)" on page 50
9Bh See "Set multiplex mode (MM --> 9Bh)" on page 50
ACh See "Command List (CL --> ACh)" on page 51
9Ch See "Set trigger mode (TM --> 9Ch)" on page 52
Command description
01h See "Single read read only code (SF --> 01h)" on page 54
1Dh See "Enhanced read only code (EF --> 1Dh)" on page 54
writing cmd
to RWw
PLC program
reading response
from RWr
Abbre
viation
CT
QU
CS
RS
RD
MM
CL
TM
Abbre
viation
SF
EF