IC-KP2-2HB18-2V1
Commands
Slave -> Master
Address
CH1
...
1)
RWr n+1+N
n:
Address in master module, specified by the assignment of the stations
*:
If 2 channels are used
N =<FixLen>/2 rounded up
1)
:
The length of the read only code (<FixLen>) depends on the transponder type.
The R/W head makes attempts until successful to read a read only code. Only
data that changes is transferred via the interface, i.e. the R/W head transfers data
whenever it reads a new read/write tag or whenever it reads a read/write tag
where there was previously no read/write head within the detection range.
The status '05h' (read command) is output whenever a read/write tag leaves the
detection range.
Bit no.
CH2*
15
...
<ID-Code>
<ID-Code>
1)
RWr n+9+N
8
7
<ID-Code>
<ID-Code>
0
55
Need help?
Do you have a question about the IDENTControl IC-KP2-2HB18-2V1 and is the answer not in the manual?