Release Sensor Removal; Carriage Home Position (Hp) Sensor Removal - Epson Stylus 1500 Service Manual

Disassembly and Assembly

3.2.7 Release Sensor Removal

1. Remove the upper housing. (See Section 3.2.1.)
2. Disconnect the cable from the connector on the sensor.
3. Remove the sensor from the left frame. (Insert tweezers to release the hook securing the sensor to the
left frame. Then pull the sensor off, as shown in the figure below.)
Twe eze rs
Figure 3-11. Removing the Release Sensor

3.2.8 Carriage Home Position (HP) Sensor Removal

1. Remove the upper housing. (See Section 3.2.1.)
2. Disconnect the cable from the connector on the sensor.
3. Remove the sensor from the paper eject frame. (Insert tweezers to release the hooks securing the sensor
to the paper eject frame. Then pull the sensor off, as shown in the figure below.)
Pap er Eject Frame
3-12
Hook for Sensor
HP Sensor
Tw eezers
Figure 3-12. Removing the HP Sensor
Stylus 1500 Service Manual
Release Sensor
Release Sensor Ca ble
HP Sensor Cable
Rev.A