Rubber Pulley And Drive Roller Removal (Drum 2 Side); Motor Harness Assy. Removal - JCM GLOBAL UBA Pro RT Series Operation And Maintenance Manual

Disassembly/Reassembly
3. Push the Bottom Course (Figure 4-118 a) in the
direction indicated by the Arrow.
4. Remove th single (1) Shaft (Figure 4-118 b) to
remove the Sponge Roller (Figure 4-118 c).
Figure 4-118 Sponge
c
Figure 4-118 Sponge Roller Assy. Removal
(Drum 2 Side) 3
Rubber Pulley and Drive Roller
Removal (Drum 2 Side)
To remove the Rubber Pulley and Drive Roller
from the Drum 2 Side, proceed as follows:
1. Release the locks and remove the Bottom Course
Assy. (Figure 4-119 a).
Figure 4-119 Rubber
Drum 2 Side
a
Figure 4-119 Rubber Pulley and Dive Roller
Removal (Drum 2 Side) 1
2. Remove the four (4) Screws (Figure 4-120
through a ).
4
Figure 4-120 Rubber
a
1
a
2
Figure 4-120 Rubber Pulley and Dive Roller
Removal (Drum 2 Side) 2
P/N 960-000213R_Rev.A
UBA Pro RT/RQ™ Series Banknote Recycler
Figure 4-121 Rubber
a
b
Figure 4-122 Rubber

Motor Harness Assy. Removal

To remove the Motor Harness Assy. out of Drum 1
or Drum 2 Unit, proceed as follows:
a
1
Figure 4-123 Motor
a
3
a
4
4 - 2 3
3. Remove the two (2) E-rings (Figure 4-121
a ) and the two (2) Bearings (Figure 4-121
2
b ).
2
a
1
b
1
Figure 4-121 Rubber Pulley and Dive Roller
Removal (Drum 2 Side) 3
4. Remove the three (3) E-rings (Figure 4-122
through a ) and the single (1) Parallel Pin (Figure
3
4-122 b).
5. Remove the two (2) Rubber Pulley (Figure 4-122
c & c ) and the single (1) Drive Roller (Figure
1 2
4-122 d).
b
a
3
c
1
a
1
Figure 4-122 Rubber Pulley and Dive Roller
Removal (Drum 2 Side) 4
NOTE: For the Drum 2 Side, follow the
"Solenoid Removal" on page 4-21 to
disassemble the Unit this far.
1. Remove the single (1) Main Drum (Figure 4-123
a) and the two (2) Washers (Figure 4-123
b ).
2
a
Figure 4-123 Motor Harness Assy. Removal 1
© 2020, JAPAN CASH MACHINE CO., LTD.
Section 4
a &
1
b &
1
b
a
2
2
a
1
d
c
2
a
2
b &
1
b
1
b
2