Note Position Sensor 1-3 Test; Note Position Sensor A-C Test - JCM GLOBAL UBA Pro RT Series Operation And Maintenance Manual

Section 6

Note Position Sensor 1-3 Test

To perform the Note Position Sensor 1 through 3
Test on the RT Transport side, proceed as follows:
1. Ensure that the Recycler and Cash Box is prop-
erly installed.
2. Launch the Performance Test Program (see
page 6-7).
3. Select "
TWIN_POSITION_SENSOR_TEST1
(Figure 6-43 a).
4. Click the " "
Start
43 b) to begin the Test.
Figure 6-43 Note Position Sensor 1 -3 Test 1
b
a
Figure 6-43 Note Position Sensor 1 -3 Test 1
5. Follow the procedures below.
NOTE: Refer to "Sensor, Roller and
Belt Locations" on page 2-16 for the
detailed Sensor locations.
Test Item
Note Position Sensor 1
Note Position Sensor 2
Note Position Sensor 3
Front
Transport
Transport
Unit
6. Confirm the "
ON/OFF
NOT Detected) appeared in the "
sensor 1 (RC-Twin)
7. Click the " "
Stop
44 b) to end the test.
Figure 6-44 Note Position Sensor 1 -3 Test 2
b
a
Figure 6-44 Note Position Sensor 1 -3 Test 2
P/N 960-000213R_Rev.A
UBA Pro RT/RQ™ Series Banknote Recycler
Screen Button (Figure 6-
Procedure
Remove the Recycler
↓
Open/close the Front Transport to
cover/uncover each Sensor
Remove the Transport Unit
↓
Cover/uncover the Sensor
Position
Sensor 3
" indication (Detected/
RC-Position
" area (Figure 6-44 a).
Screen Button (Figure 6-
Scroll

Note Position Sensor A-C Test

To perform the Note Position Sensor A through C
Test on the RT Transport side, proceed as follows:
1. Ensure that the Recycler and Cash Box is prop-
erly installed.
2. Launch the Performance Test Program (see
page 6-7).
" 3. Select "
TWIN_POSITION_SENSOR_TEST2
(Figure 6-45 a).
4. Click the "
45 b) to begin the Test.
Figure 6-45 Note Position Sensor A -C Test 1
a
Figure 6-45 Note Position Sensor A -C Test 1
5. Follow the procedures below.
NOTE: Refer to "Sensor, Roller and
Belt Locations" on page 2-16 for the
detailed Sensor locations.
Test Item
Note Position Sensor A
Note Position Sensor B
Note Position Sensor C
6. Confirm the "
NOT Detected) appeared in the "
sensor 2 (RC-Twin)
7. Click the "
46 b) to end the test.
Figure 6-46 Note Position Sensor A -C Test 2
b
Figure 6-46 Note Position Sensor A -C Test 2
© 2020, JAPAN CASH MACHINE CO., LTD.
6 - 1 0
Calibration and Testing
" Screen Button (Figure 6-
Start
b
Procedure
Remove/reseat the Recycler to
cover/uncover the Sensors.
" indication (Detected/
ON/OFF
RC-Position
" area (Figure 6-46 a).
" Screen Button (Figure 6-
Stop
a
"
Scroll