Communication Test; Status Led Test - JCM GLOBAL UBA Pro RT Series Operation And Maintenance Manual

Section 6

Communication Test

To test the communication between UBA Pro and
RT/RQ Unit, proceed as follows:
1. Remove electrical power.
2. Set the DIP Switches of the UBA Pro Unit as
below (Figure 6-72).
Figure 6-72 Communication Test 1
DIP Switches #1, #2, #5, #8 ON
ON
1 2 3
Figure 6-72 Communication Test 1
3. Set the DIP Switches of the RT/RQ Unit as below
(Figure 6-73).
Figure 6-73 Communi-
DIP Switches All OFF
ON
1 2 3
Figure 6-73 Communication Test 2
4. Apply electrical power.
5. Confirm that the Status LED/Collect Button is lit
at Green Color and then turns off.
NOTE: Wait for the Status LED to turn off
in order to run the test properly.
Figure 6-74 Communication
Figure 6-74 Communication Test 3
6. To start the Test, set the UBA Pro DIP Switch #8
to (Figure 6-75).
OFF
Figure 6-75 Communi-
DIP Switch #8 OFF
ON
1 2 3
Figure 6-75 Communication Test 4
7. The UBA Pro Green
when the UBA Pro Unit is communicating with
the RT/RQ Unit successfully.
8. Set the UBA Pro DIP Switch #8 to
test.
P/N 960-000213R_Rev.A
UBA Pro RT/RQ™ Series Banknote Recycler
4 5 6 7 8
4 5 6 7 8
Green ON
OFF
4 5 6 7 8
Status LED will turn on
to end the
ON

Status LED Test

To test the RT/RQ Unit Status LED's performance,
proceed as follows:
1. Remove electrical power.
2. Set the DIP Switches of the UBA Pro Unit as
below (Figure 6-76).
Figure 6-76 Status
DIP Switches #1, #2, #5, #8 ON
ON
1 2 3
Figure 6-76 Status LED Test 1
3. Set the DIP Switches of the RT/RQ Unit as below
(Figure 6-77).
Figure 6-77 Status
DIP Switch #5 ON
ON
1 2 3
Figure 6-77 Status LED Test 2
4. Apply electrical power.
5. Confirm that the Status LED/Collect Button is lit
at Green Color and then turns off.
NOTE: Wait for the Status LED to turn off
in order to run the test properly.
Figure 6-78 Status LED Test 3
Figure 6-78 Status LED Test 3
6. To start the Test, set the UBA Pro DIP Switch #8
to (Figure 6-79).
OFF
Figure 6-79 Status
DIP Switch #8 OFF
ON
1 2 3
Figure 6-79 Status LED Test 4
7. Press the RT/RQ Unit's Status LED/Collect 
Button.
8. Confirm that the Status LED is lit in the follow-
ing sequential order each time when pressing the
Status LED/Collect Button:
Green => Magenta
=> Yellow
OFF
9. Set the UBA Pro DIP Switch #8 to
test.
© 2020, JAPAN CASH MACHINE CO., LTD.
6 - 1 8
Calibration and Testing
4 5 6 7 8
4 5 6 7 8
Green ON OFF
4 5 6 7 8
=> Cyan => Blue
=> Red => White =>
to end the
ON