Rubber Pulley And Drive Roller Removal (Drum 1 Side); Solenoid Removal - JCM GLOBAL UBA Pro RT Series Operation And Maintenance Manual

Disassembly/Reassembly
Rubber Pulley and Drive Roller
Removal (Drum 1 Side)
To remove the Rubber Pulley and Drive Roller
from the Drum 1 Side, proceed as follows:
1. Remove the two (2) E-rings (Figure 4-105
a ) and the two (2) Bearings (Figure 4-105
2
b ).
2
Figure 4-105 Rubber
a
b
1
1
Drum 1 Side
Figure 4-105 Rubber Pulley and Dive Roller
Removal (Drum 1 Side) 1
2. Remove the three (3) E-rings (Figure 4-106
through a ) and the single (1) Parallel Pin (Figure
3
4-106 b).
3. Remove the two (2) Rubber Pulleys (Figure 4-
106 c & c ) and the single (1) Drive Roller (Fig-
1 2
ure 4-106 d).
Figure 4-106 Rubber a
1
c
1
b
a
d
3
Figure 4-106 Rubber Pulley and Dive Roller
Removal (Drum 1 Side) 2

Solenoid Removal

To remove the Solenoid from the Drum 1 Side,
proceed as follows:
1. Rotate the Handle (Figure 4-107 a) all the way in
the direction indicated by the Arrow.
Figure 4-107 Sole-
Drum 1 Side
Figure 4-107 Solenoid Removal 1
P/N 960-000213R_Rev.A
UBA Pro RT/RQ™ Series Banknote Recycler
a &
1
b &
1
b
2
a
2
a
1
a
2
c
2
a
4 - 2 1
2. Pull out the two (2) Tapes (Figure 4-108
3. Peel off the Clip Sticker (Figure 4-108 b).
Figure 4-108 Sole-
b
Figure 4-108 Solenoid Removal 2
4. Remove the two (2) Clips (Figure 4-109
a
Figure 4-109 Sole-
1
Figure 4-109 Solenoid Removal 3
5. Peel off and separate Tapes (Figure 4-110
through a ).
4
Figure 4-110 Sole-
Figure 4-110 Solenoid Removal 4
6. Remove the single (1) E-ring (Figure 4-111 a),
the single (1) Handle (Figure 4-111 b), the single
(1) Parallel Pin (Figure 4-111 c), and the single
(1) Bearing (Figure 4-111 d).
Figure 4-111 Sole-
Figure 4-111 Solenoid Removal 5
© 2020, JAPAN CASH MACHINE CO., LTD.
Section 4
a & a ).
1 2
a
1
a
2
a & a ).
1 2
a
2
a
1
a a
1 2
a
a
3
4
d
b
c
a