Cleaning Procedure; Sensor And Roller Cleaning Procedure - JCM GLOBAL VEGA-RC Twin Series Integration Manual

Cleaning Procedure

To clean the VEGA-RC Twin™ Recycler section,
gently rub the sensors and rollers using ONLY a
dry, soft, lint-free cloth.
Do not use any alcohol, solvents, citrus-based
products, or scouring agents. These can cause dam-
age to the validation section sensors and/or rollers.
S R
ENSOR AND OLLER
To clean the VEGA-RC Twin™ Unit, proceed as
follows:
1. Turn the VEGA-RC Twin™ Unit's power supply
OFF.
2. Open the VEGA-RC Twin™ Unit's Rear Cover.
3. Clean the appropriate path, lens and roller. Be
sure to rotate the Drum Thumb Winding Gear
Controls (See Figure 10 a) in the "
when cleaning the rubber rollers (See Figure 10
b) using the soft-lint free cloths.
a
Figure 10 Roller Cleaning
Caution: DO NOT rotate the Drum
Thumb Winding Gear Controls in the out
direction when cleaning! The Transport
Belt could wind in the wrong direction,
causing poor performance.
Caution: Do not use alcohol, thinner or
citrus-based products for cleaning any
Banknote Transport Sensors or
surfaces. The lenses can become
clouded by chemical evaporation
residue, causing acceptance errors.
P/N 960-000169R_Rev. A {EDP #217859}
VEGA-RC Twin™ Series Banknote Recycler Integration Guide
C P
LEANING ROCEDURE
" direction
IN
b
Lens Roller
Lint-free Cloth/Cotton Swab/Air
Figure 11 Sensor Cleaning
© 2012, Japan CashMachine Co., Limited
1 0
Before
Cleaning
Belt
After
Cleaning