Rt Transport Performance Tests - JCM GLOBAL UBA Pro RT Series Operation And Maintenance Manual

Section 6

RT Transport Performance Tests

This section provides instructions for conducting a
Performance Test Without a PC on the RT 
Transport side (Figure 6-71 a).
Feed Motor Normal Rotation Test 
(RT Transport)
To run the Feed Motor Normal Rotation Test on the
RT Transport side, proceed as follows:
1. Remove electrical power.
2. Set the DIP Switches of the UBA Pro Unit as
below (Figure 6-90).
Figure 6-90 Feed
DIP Switches #1, #2, #6, #8 ON
ON
1 2 3
Figure 6-90 Feed Motor Normal Rotation Test
(RT Transport) 1
3. Set the DIP Switches of the RT/RQ Unit as below
(Figure 6-91).
Figure 6-91 Feed
DIP Switch #1 ON
ON
1 2 3
Figure 6-91 Feed Motor Normal Rotation Test
(RT Transport) 2
4. Apply electrical power.
5. Confirm that the Status LED/Collect Button is lit
at Green Color and then turns off.
NOTE: Wait for the Status LED to turn off
in order to run the test properly.
Figure 6-92 Feed Motor Nor-
Figure 6-92 Feed Motor Normal Rotation Test
(RT Transport) 3
P/N 960-000213R_Rev.A
UBA Pro RT/RQ™ Series Banknote Recycler
4 5 6 7 8
4 5 6 7 8
Green ON
OFF
6. Remove the Recycler from the RT Transport.
Figure 6-93 Feed Motor
Figure 6-93 Feed Motor Normal Rotation Test
(RT Transport) 4
7. To start the Test, set the UBA Pro DIP Switch #8
to (Figure 6-94).
OFF
Figure 6-94 Feed
DIP Switch #8 OFF
ON
1 2 3
Figure 6-94 Feed Motor Normal Rotation Test
(RT Transport) 5
8. The Belts of the Transport Unit will start running
in the normal rotation direction when the Feed
Motor functions properly.
Figure 6-95 Feed Motor Nor-
Figure 6-95 Feed Motor Normal Rotation
Test (RT Transport) 6
9. Set the UBA Pro DIP Switch #8 to
test.
© 2020, JAPAN CASH MACHINE CO., LTD.
6 - 2 0
Calibration and Testing
4 5 6 7 8
to end the
ON