Table of Contents
Advertisement
Section 4
5. Remove the four (4) screws (Figure 4-4
through
a
) securing the CPU Protective Sheet
4
(Figure 4-4 b) and remove the CPU Protective
Sheet from the Unit.
Figure 4-4 CPU Protective Sheet Removal
a
1
a
2
a
3
a
4
Figure 4-4 CPU Protective Sheet Removal
6. Disconnect the five (5) connectors (Figure 4-5
through
a
).
5
NOTE: Release the Connector Lock before
removing the FFC (Figure 4-5).
7. Remove the two (2) screws (Figure 4-5
securing the Main Board (Figure 4-5 c), and then
remove the Main Board from the Unit.
Figure 4-5 Main Board Removal
Connector Lock
FFC
Figure 4-5 Main Board Removal
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
a
1
b
b
&
1
a
1
a
2
a
3
a
a
5
c
b
1
b
2
8. Disconnect the two (2) connectors (Figure 4-6
&
a
) and remove the two (2) LED Sponges (Fig-
2
ure 4-6
b
&
1
c).
Figure 4-6 Connector Removal
a
1
Figure 4-6 Connector Removal
NOTE: When replacing the Main Board, be
sure to change the LED Sponges at the
a
1
same time. The LED Sponge adhesive
looses strength once removed from the
Main Board and may fall off while in
operation.
b
)
NOTE: The LED Sponge is a separate part
2
from the Main Board. When replacing the
Main Board, the LED Sponges need to be
ordered and installed as independent
parts.
Side Sensor Board Removal
To remove the Side Sensor Board, proceed as
follows:
1. Remove the two (2) screws (Figure 4-7
4
securing the two (2) Side Sensor Boards (Figure
4-7
b
& c) and disconnect the two (2) connectors
(Figure 4-7
Figure 4-7 Side Sensor Board Removal
b
a
d
1
1
Figure 4-7 Side Sensor Board Removal
© 2020 JAPAN CASH MACHINE CO., LTD.
4 - 2
Disassembly/Reassembly
b
) from the Main Board (Figure 4-6
2
b
1
b
2
a
2
c
d
&
d
).
1
2
d
2
a
1
a
&
a
)
1
2
c
a
2
Advertisement
Table of Contents
