Cc-Talk Interface Connector Pin Assignments (Uba Pro Side) - JCM GLOBAL UBA Pro RT Series Operation And Maintenance Manual

Installation

cc-Talk Interface Connector Pin Assignments (UBA Pro Side)

NOTE: The Interface setup is required. Refer to "Interface and Recycler Settings (Sub Board 2)" on
page 2-4 for the settings.
Table 2-8 cc-Talk Interface Connector Pin Assignments (UBA Pro Side)
Pin No. Signal Name
1
2
3 M.RES
4
5
6
7
8
9
10
11
12
13 GND (I/F)
14 LED POWER
15
16 TXD
17
18
19
20
*. I/O (input/output) is the terminal as viewed from the RT/RQ Unit's side.
P/N 960-000213R_Rev.A
UBA Pro RT/RQ™ Series Banknote Recycler
*
I/O
- -
- -
IN
NC -
- -
NC -
NC -
NC -
NC -
NC -
- -
NC -
-
-
- -
OUT
- -
LED -
NC -
- -
Socket (UBA Pro Unit Side): DRA-20PC-FO (JAE)
Contact (UBA Pro Unit Side): D02-22-26P-10000 (JAE)
Socket (Frame Side): DRA-20SC-FO (JAE)
Contact (Frame Side): D02-22-26S-10000 (JAE)
Contact (Frame Side) Pin No.3, No.13: D02-22-22S-10000 (JAE)
Recommended Wires: Slit Wire UL1061 AWG #26
Reserved (For the UBA Pro Side)
Reserved (For the UBA Pro Side)
Acceptor Hard Reset Signal Line
No Connection
Reserved (For the UBA Pro Side)
No Connection
No Connection
No Connection
No Connection
No Connection
Reserved (For the UBA Pro Side)
No Connection
Interface Power Supply (cc-Talk 0V DC)
LED Indicator Power Supply Line (Anode)
Reserved (For the UBA Pro Side)
Output Signal Line from Acceptor to Host
Reserved (For the UBA Pro Side)
LED Indicator Control Line (Cathode)
No Connection
Reserved (For the UBA Pro Side)
2 - 9
Function
© 2020, JAPAN CASH MACHINE CO., LTD.
Section 2