Danfoss VLT Refrigeration Drive FC 103 Programming Manual page 163

Parameter Description
23-04 Occurrence
Array [10]
Option: Function:
Select which day(s) the timed action
applies to. Specify working/non-working
days in:
•
•
•
[0] All days
*
[1] Working days
3.19.2 23-1* Maintenance
Wear and tear calls for periodic inspection and service of elements in the application, for example motor bearings, feedback
sensors, seals, and filters. With preventive maintenance, the service intervals may be programmed into the frequency
converter. The frequency converter gives a message when maintenance is required. 20 preventive maintenance events can
be programmed into the frequency converter.
Specify the following for each event:
•
Maintenance item (for example, motor bearings).
•
Maintenance action (for example, replacement).
•
Maintenance time base (for example, running hours, or a specific date and time).
•
Maintenance time interval or the date and time of next maintenance.
NOTICE
To disable a preventive maintenance event, set the associated parameter 23-12 Maintenance Time Base to [0] Disabled.
Preventive maintenance can be programmed from the LCP, but use of the PC-based MCT 10 Set-up Software is
recommended.
MG16H202
Programming Guide
Parameter 0-81 Working Days.
Parameter 0-82 Additional Working
Days.
Parameter 0-83 Additional Non-
Working Days.
Danfoss A/S © 05/2016 All rights reserved.
23-04 Occurrence
Array [10]
Option: Function:
[2] Non-working
days
[3] Monday
[4] Tuesday
[5] Wednesday
[6] Thursday
[7] Friday
[8] Saturday
[9] Sunday
3 3
161