Danfoss VLT AutomationDrive FC 302 Programming Manual page 33

Parameter Descriptions
•
0-30 Custom Readout Unit
•
0-31 Custom Readout Min Value (linear only)
•
Parameter 0-32 Custom Readout Max Value
•
4-13 Motor Speed High Limit [RPM]
•
Parameter 4-14 Motor Speed High Limit [Hz]
•
and actual speed
Custom Readout (Value)
P 16-09
Custom Readout
Unit P 0-30
Max value
P 0-32
Min value
Linear
units only
P 0-31
0
Illustration 3.4 Custom Readout
The relation depends on the type of unit selected in
0-30 Custom Readout Unit:
Unit type
Dimensionless
Speed
Flow, volume
Flow, mass
Velocity
Length
Temperature
Pressure
Power
Table 3.3 Speed Relations for Different Unit Types
0-30 Unit for User-defined Readout
Option: Function:
It is possible to program a value to be shown in
the display of the LCP. The value has a linear,
squared or cubed relation to speed. This relation
depends on the unit selected (see Table 3.3). The
actual calculated value can be read in
parameter 16-09 Custom Readout, and/or shown in
the display by selecting [16-09] Custom Readout in
parameter 0-20 Display Line 1.1 Small to
0-24 Display Line 3 Large.
[0] None
*
[1] %
[5] PPM
MG33MJ02
Programming Guide
Motor Speed
Motor Speed
High limit
P 4-13 (RPM)
P 4-14 (Hz)
Speed relation
Linear
Quadratic
Cubic
Danfoss A/S © Rev. 10/2014 All rights reserved.
0-30 Unit for User-defined Readout
Option: Function:
[10] 1/min
[11] rpm
[12] Pulse/s
[20] l/s
[21] l/min
[22] l/h
[23] m³/s
[24] m³/min
[25] m³/h
[30] kg/s
[31] kg/min
[32] kg/h
[33] t/min
[34] t/h
[40] m/s
[41] m/min
[45] m
[60] °C
[70] mbar
[71] bar
[72] Pa
[73] kPa
[74] m WG
[80] kW
[120] GPM
[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[125] ft³/s
[126] ft³/min
[127] ft³/h
[130] lb/s
[131] lb/min
[132] lb/h
[140] ft/s
[141] ft/min
[145] ft
[160] °F
[170] psi
[171] lb/in²
[172] in WG
[173] ft WG
[180] HP
0-31 Min Value of User-defined Readout
Range:
0 CustomRea- [ -999999.99 -
doutUnit par. 0-32
*
CustomRea-
doutUnit]
Function:
This parameter sets the min.
value of the custom-defined
readout (occurs at zero speed).
only possible to set different
from 0 when selecting a linear
31
3 3