Danfoss VLT AutomationDrive FC 302 Programming Manual page 169

Parameter Descriptions
17-71 Absolute Position Display Scale
Select the decimal power of the readout scale. The readout scale
is 1:10^(VALUE). For instance, the default value 0 means that the
scale is 1:10^0 = 1:1.
Range:
0 [-7 - 7]
*
17-72 Absolute Position Numerator
If there are gears between the motor shaft and the application
shaft, the absolute position of the motor shaft should be
multiplied by a ratio to get the absolute position of the
application shaft. Enter the numerator of the ratio. Scaling ration
equals to (parameter 17-72 Absolute Position Numerator)/
(parameter 17-73 Absolute Position Denominator).
Range:
4096 [-2000000000 -
*
2000000000]
17-73 Absolute Position Denominator
If there are gears between the motor shaft and the application
shaft, the absolute position of the motor shaft should be
multiplied by a ratio to get the absolute position of the
application shaft. Enter the denominator of the ratio. Scaling
ration equals to (parameter 17-72 Absolute Position Numerator)/
(parameter 17-73 Absolute Position Denominator).
Range:
1 [-2000000000 -
*
2000000000]
17-74 Absolute Position Offset
Enter the absolute position offset. Use this parameter if manual
adjustment of the absolute position readout is required.
Range:
0 [-2000000000 -
*
2000000000]
MG33MJ02
Programming Guide
Function:
Function:
Function:
Function:
Danfoss A/S © Rev. 10/2014 All rights reserved.
3 3
167