Video Port Status Register (Vpstat); Video Port Status Register (Vpstat) Field Descriptions - Texas Instruments TMS320C64x DSP Reference Manual

Video Port Control Registers
2.7.2

Video Port Status Register (VPSTAT)

The video port status register (VPSTAT) indicates the current condition of the
video port. The VPSTAT is shown in Figure 2–4 and described in Table 2–7.
Figure 2–4. Video Port Status Register (VPSTAT)
31
15
Legend: R = Read only; -n = value after reset; -x = value is determined by chip-level configuration
Table 2–7. Video Port Status Register (VPSTAT) Field Descriptions
†
Bit field symval
31–4 Reserved –
3 DCDIS
ENABLE
DISABLE
2 HIDATA
NONE
USE
1–0 Reserved –
† For CSL implementation, use the notation VP_VPSTAT_field_symval
2-20 Video Port
Reserved
R-0
Reserved
R-0
†
Value Description
0 Reserved. The reserved bit location is always read as 0. A value
written to this field has no effect.
Dual-channel disable bit. The default value is determined by the
chip-level configuration.
0 Dual-channel operation is enabled.
1 Port muxing selections prevent dual-channel operation.
High data bus half. HIDATA does not affect video port operation
but is provided to inform you which VDATA pins may be controlled
by the video port GPIO registers. HIDATA is never set unless
DCDIS is also set. The default value is determined by the
chip-level configuration.
0
1 Indicates that another peripheral is using VDATA[9–0] and the
video port channel A (VDIN[9–0] or VDOUT[9–0]) is muxed onto
VDATA[19–10].
0 Reserved. The reserved bit location is always read as 0. A value
written to this field has no effect.
4 3 2 1
DCDIS HIDATA Reserved
R-x R-x R-0
SPRU629
16
0