Analog Output Block - Emerson Rosemount 5900S Reference Manual

Reference Manual
00809-0100-5900
Table C-3: Definitions of Analog Input Function Block System Parameters
Index Number Parameter
38 ALARM_SEL
39 STDDEV
40 CAP_STDDEV
C.2.1 Simulation
To perform lab test of process variables and alerts, you can either change the mode of the
AI block to manual and adjust the output value, or you can enable simulation through the
configuration tool and manually enter a value for the measurement value and its status. In
both cases, you must first set the SIMULATE switch (1) on the field device to the ON
position, see Simulation.
With simulation enabled, the actual measurement value has no impact on the OUT value
or the status.
C.3

Analog Output block

Figure C-3: Analog-Output Block
A. CAS_IN = The remote setpoint value from another function block
B. BKCAL_OUT = The value and status required by the BKCAL_IN input of another block to
C. OUT = The block output value and status
The Analog Output (AO) function block assigns an output value to a field device through a
specified I/O channel. The block supports mode control, signal status calculation, and
simulation.
Output
Table C-4: Analog Output Function Block System Parameters
Parameter
BKCAL_OUT
Rosemount 5900S Radar Level Gauge
Units Description
None Used to select the process alarm conditions that will cause the
OUT_D parameter to be set.
Percent The average absolute error between the PV and its previous mean
value over that evaluation time defined by VAR_SCAN.
Seconds The time over which the VAR_INDEX is evaluated.
prevent reset windup and to provide bumpless transfer to closed loop control.
Table C-4 lists the definitions of the system parameters. See also
block.
Units
EU of PV_SCALE The value and status required by the BKCAL_IN input of
F
OUNDATION
Description
another block to prevent reset windup and to provide
bumpless transfer to closed loop control.
™
Fieldbus Block Information
September 2019
(continued)
Analog
277