Volume Transducer Block - Emerson Rosemount 5900S Reference Manual

™
F Fieldbus Block Information
OUNDATION
September 2019
Table C-15: Device Alerts
Value
0x0020 0000
0x0040 0000
0x1000 0000
0x2000 0000
C.5

Volume Transducer block

Table C-16: Volume Transducer Block Parameters
Index
Number
1
2
3
4
5
6
7
8
9
286
(continued)
Description
Configuration error
Software error
Simulation Mode
Software write protected
Parameter
ST_REV
TAG_DESC
STRATEGY
ALERT_KEY
MODE_BLK
BLOCK_ERR
UPDATE_EVT
BLOCK_ALM
TRANSDUCER_DIRECTORY
Description
The revision level of the static data associated with
the function block. The revision value increments
each time a static parameter value in the block is
changed.
The user description of the intended application of
the block.
The strategy field can be used to identify grouping of
blocks. This data is not checked or processed by the
block.
The identification number of the plant unit. This
information may be used in the host for sorting
alarms, etc.
The actual, target, permitted, and normal modes of
the block. Target: The mode to "go to" Actual: The
mode the "block is currently in" Permitted: Allowed
modes that target may take on Normal: Most
common mode for target
This parameter reflects the error status associated
with the hardware or software components
associated with a block. It is a bit string, so that
multiple errors may be shown.
This alert is generated by any change to the static
data
The block alarm is used for all configuration,
hardware, connection failure or system problems in
the block. The cause of the alert is entered in the
subcode field. The first alert to become active will set
the Active status in the Status parameter. As soon as
the Unreported status is cleared by the alert
reporting task, another block alert may be reported
without clearing the Active status, if the subcode has
changed.
Directory that specifies the number and starting
indices of the transducers in the transducer block.
Reference Manual
00809-0100-5900
Reference Manual