Emerson Rosemount 5900S Reference Manual page 270

™
F Fieldbus Block Information
OUNDATION
September 2019
Table C-1: Resource Block Parameters
Index Parameter
Number
39 WRITE_PRI
40 WRITE_ALM
41 ITK_VER
42 FD_VER
43 FD_FAIL_ACTIVE
44 FD_OFFSPEC_ACTIVE
45 FD_MAINT_ACTIVE
46 FD_CHECK_ACTIVE
47 FD_FAIL_MAP
48 FD_OFFSPEC_MAP
49 FD_MAINT_MAP
50 FD_CHECK_MAP
51 FD_FAIL_MASK
52 FD_OFFSPEC_MASK
53 FD_MAINT_MASK
54 FD_CHECK_MASK
55 FD_FAIL_ALM
56 FD_OFFSPEC_ALM
57 FD_MAINT_ALM
58 FD_CHECK_ALM
59 FD_FAIL_PRI
60 FD_OFFSPEC_PRI
61 FD_MAINT_PRI
62 FD_CHECK_PRI
63 FD_SIMULATE
270
(continued)
Description
Priority of the alarm generated by clearing the write lock.
This alert is generated if the write lock parameter is cleared.
Major revision number of the inter operability test case used in certifying
this device as interoperable. The format and range are controlled by the
Fieldbus Foundation.
A parameter equal to the value of the major version of the Field
Diagnostics specification that this device was designed to.
This parameter reflects the error conditions that are being detected as
active as selected for this category. It is a bit string, so that multiple
conditions may be shown.
This parameter maps conditions to be detected as active for this alarm
category. Thus the same condition may be active in all, some, or none of
the 4 alarm categories.
This parameter allows the user to suppress any single or multiple
conditions that are active, in this category, from being broadcast to the
host through the alarm parameter. A bit equal to '1' will mask i.e. inhibit
the broadcast of a condition, and a bit equal to '0' will unmask i.e. allow
broadcast of a condition.
This parameter is used primarily to broadcast a change in the associated
active conditions, which are not masked, for this alarm category to a
Host System.
This parameter allows the user to specify the priority of this alarm
category.
This parameter allows the conditions to be manually supplied when
simulation is enabled. When simulation is disabled both the diagnostic
simulate value and the diagnostic value tracks the actual conditions. The
simulate jumper is required for simulation to be enabled and while
simulation is enabled the recommended action will show that simulation
is active.
Elements: see Table C-2.
Reference Manual
00809-0100-5900
Reference Manual