Displays And Help Messages During Adjustment/Calibration - Sirona GALILEOS Service Manual

7 Adjusting/calibrating the unit
7.1 General information about unit adjustment and calibration
Help messages
Status messages
158
7.1.1 Displays and help messages during adjustment/
calibration

Displays and help messages during adjustment/calibration

The most frequent help and status messages during calibration are listed
below.
H3 01: Move unit to starting position, press the R key.
H3 07: Remove the occlusal bite block.
H3 21: Close the door.
H323/3244 GALILEOS
H3 23: Close swivel arm.
H3 24: Gettering in progress, please wait.
H4 03: SIDEXIS XG is not ready for exposure, make unit ready for
exposure.
GALILEOS status messages Easypad
"Ready for exposure"
"Exposure not possible"
"Please wait"
"Ready for exposure in XXs"
"X RAY Active!"
If error message E1 11 20 is displayed on the control panel and/or the
remote control during the calibration process, this does not necessarily
indicate an equipment error. This error message only indicates that the
adjustment or calibration data of the unit is incomplete at this point.
Acknowledge the error message with the R key, if applicable, and
continue the adjustment or calibration procedure.
For assistance with other help messages or error messages displayed
during the adjustment or calibration process, please refer to the section
of these instructions entitled Messages [ → 82].
Sirona Dental Systems GmbH
Service Manual GALILEOS
Multipad
no special display;
kV level and mAs are displayed
S110
Progress bar
XXs
LED lights up on control panel
61 25 665 D3437
D3437.076.01.15.02 06.2012