List Of Messages; List Of Help Messages - Sirona Orthophos XG Plus DS/Ceph Operating Instructions Manual

13 List of messages

13.1 List of help messages

13
List of messages
13.1
List of help messages
A number of H3 help messages may appear on the Easypad while you attempt to release an exposure:
• Press the exposure release button. ATTENTION Observe radiation protection measures.
The message H3/H4 ... – Message appears on the Easypad.
• See list below about how to proceed to make the system ready for exposure.
Help
message
R button, move into starting position.
H3 01
R button, confirm exposure data.
H3 20
Close the door
H3 21
Select quadrant
H3 22
Plug sensor into PAN slot.
H4 01
Plug sensor into Ceph slot.
H4 02
Switch SIDEXIS to ready for exposure state
H4 03
Plug in Ceph sensor
H4 04
Plug in TSA sensor
H4 05
R button, move into Ceph starting position.
H4 06
Call up existing exposure.
H4 20
The above measures clear those help messages that result from operator errors.
If it is not possible to clear the help message by taking the appropriate measure, another type of error is the cause.
To locate the error, proceed as described on the following pages.
114
Actions required
Operating Instructions ORTHOPHOS XG
Description
The rotating element is not in the starting position.
The exposure data have not been acknowledged yet.
Check door contact of the X-ray room.
Select the desired quadrant.
The sensor is not in the appropriate slot for the
selected exposure type.
The sensor is not in the appropriate slot for the
selected exposure type.
SIDEXIS is not ready for exposure.
The sensor does not match the selected exposure
type
The sensor does not match the selected exposure
type
Ceph is not in the starting position
The image could not be transferred to SIDEXIS. See
SIDEXIS Operator's Manual.
ATTENTION Do not switch off the system until the
help message has disappeared.
Sirona Dental Systems GmbH
Plus
DS/Ceph
59 87 594 D 3352
D 3352.201.01.18.02