1Replacing Fiber-Optic Cable L5, L6 Or L15 - Sirona GALILEOS Service Manual

Sirona Dental Systems GmbH
Service Manual GALILEOS
61 25 665 D3437
D3437.076.01.15.02 06.2012
Replacing fiber-optic cable L5, L6 or L15
9.13.2.1
Replacing fiber-optic cable L5, L6 or L15
IMPORTANT: If a radius limiter is not yet installed: When replacing one
cable, all existing fiber-optic cables (L5, L6 or L15) should be retrofitted
with the radius limiters included with delivery! The radius limiters improve
torsional and bending force tolerance.
1. Remove the defective fiber-optic cable.
2. NOTICE! Do not kink or twist fiber-optic cables, the bending radius
may not be less than 20mm, otherwise it is at risk of breaking!
Attach the radius limiter (A) close to the connector, which is plugged
onto board DX1, onto the cable.
3. Plug the connector of the new fiber-optic cable to the same color
assignment on the board DX1.
4. Lay the fiber-optic cables up to point (B), and clip the radius limiter (A)
at point (B) (approx. 900 mm from the connectors on DX1) onto the
cable.
5. Guide the fiber-optic cable to board DX6 and plug the connector of
the new fiber-optic cable to the same color assignment on board DX6.
9 Repair
9.13 Cable
363