Accessories; Opening The Grinding Chamber Door During The Production Process; Wireless Phone Interference With Equipment; Disturbance Of Data Transmission - Sirona CEREC MC XL Operating Instructions Manual

4 Safety
4.2 Opening the grinding chamber door during the production process
Note on wireless communication
10
4.1.4

Accessories

In order to ensure product safety, this device may be operated only with
Product safety of inEos X5
original Sirona accessories or third-party accessories expressly approved
by Sirona. In particular, only the power cable supplied with the unit or the
corresponding original spare part may be used with the unit. The user
assumes the risk of using non-approved accessories.
4.2
Opening the grinding chamber door during the
production process
CAUTION
Instruments that continue to run
When the grinding chamber door is opened during the production
process, the instruments could continue to run for a short time.
➢ Be careful not to touch the instruments with your hand or any other
object during this time.
➢ Avoid opening the grinding chamber door while the grinding unit is
in operation.
➢ Before you open the grinding chamber door, end any actions that
are running by selecting the
application software.
4.3

Wireless phone interference with equipment

The use of mobile wireless phones in practice or hospital environments
must be prohibited to ensure safe operation of the unit.
4.4

Disturbance of data transmission

Data communication between the acquisition unit and the CEREC MC XL
Note on wireless communication
grinding unit should preferably be established via the wireless H&W
interface or WLAN. As for all wireless connections (e.g. cell phones),
heavy utilization of the available radio channels or shielding caused by
building installations (e.g. metal-shielded X-ray enclosures) may impair
the quality of the connection. This may become noticeable through a
reduction in range and/or a slower data transmission rate. In extreme
cases, it will be impossible to establish a wireless connection at all.
Sirona has selected the best possible configuration for data
communication via the wireless H&W interface or WLAN, which generally
provides perfect functioning of this connection. However, in individual
cases unrestricted wireless data communication may be impossible for
the reasons mentioned above and/or due to local circumstances. In such
cases, a cable LAN connection should be selected to ensure
uninterrupted operation. If the only LAN interface on the rear of the
CEREC AC is occupied by another plug, remove this H&W wireless
interface connection and instead connect the LAN cable with the CEREC
MC XL grinding unit.
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
"Stop"
key on the grinding unit or in the
61 46 885 D 3439
D 3439.201.02.19.02 12.2014