Location 12: Can Bus - Sirona GALILEOS Service Manual

Sirona Dental Systems GmbH
Service Manual GALILEOS
Error code Description
E1 11 19 No image data available.
Error code Description
E1 11 20 The calibration data on the unit is
invalid or does not match the serial
numbers of the modules.
Error code Description
E2 11 22 The default iris table is write-
protected.
Error code Description
E1 11 23 No matching iris diaphragm setting
is available for the current program
parameters.
Error code Description
E1 11 88 The unit is in demo mode.
Occurs when the unit is switched on.
Error code Description
E6 12 01 CAN controller initialization error on
DX1.
Error code Description
E6 12 02 CAN malfunction (cannot be
assigned to module).
61 25 665 D3437
D3437.076.01.15.02 06.2012
E1 11 19 GALILEOS
Actions required
● Check TDI signal (synchronized readout
sequence)/cable L13, replace cable L13 if
necessary.
● Replace board DX89.
● Replace board DX1.
E1 11 20 GALILEOS
Actions required
● Calibrate the unit.
If the error occurs again and no modules were
replaced ...
● Replace board DX11.
If the error occurs again and modules were
replaced ...
● This error is a sequential fault. watch for
additional causal error messages and take
the respective action.
E2 11 22 GALILEOS Actions required
● Check the software versions of SIDEXIS
XG and the unit for compatibility, perform
software update if necessary.
E1 11 23 GALILEOS Actions required
● Check the software versions of SIDEXIS
XG and the unit for compatibility, perform
software update if necessary.
E1 11 88
Actions required
If user mode is expressly required ...
● Switch the demo mode off.
CAUTION! Radiation can be released
after the demo mode is switched off!
5.5.5

Location 12: CAN bus

Location 12: CAN bus
Actions required
● Check the CAN bus.
E6 12 02
Actions required
● Check the CAN bus.
5 Messages
5.5 List of error messages
see
S. [ → 362]
S. [ → 343]
S. [ → 343]
see
S. [ → 155]
S. [ → 343]
see
S. [ → 61]
see
S. [ → 61]
see
S. [ → 81]
see
S. [ → 128]
see
S. [ → 128]
103