Set-Up; History File; Calibration Check - Sirona SIROLaser Xtend Operating Instructions Manual

5 Operation
5.5 Main home screen
46
5.5.4

Set-up

5.5.4.1

History file

The history file is only available after the upgrade.
After having finished a treatment all parameters will be saved and
documented in the history file - i.e. user name, application, date & time
as well as power, laser activation time, energy, and average power of
this treatment.
NOTE
A maximum of 50 treatments is possible to be stored. If the maximum
is reached the 51st treatment will replace the 1st treatment.
When downloading the history file the data will be deleted from the
control unit.
CAUTION
Use only USB Class 2.0 memory sticks.
➢ To download the history file please insert an USB mass storage
(class version 2.0) and press the 'save' button.
Ä Proceed as instructed on the screen.
5.5.4.2

Calibration check

WARNING
You must wear the supplied laser protective goggles during the entire
calibration check.
The following section describes the procedure to check the calibration
of the SIROLaser Xtend.
We recommend performing this check at least once a week.
In order to enable exact inspection of the performance and flawless
functioning of your SIROLaser Xtend, we recommend performing
calibration check at three or rather four different power levels:
● 1 W
● 3 W
● 5 W
● 7 W (only after the upgrade)
The SIROLaser Xtend performs a self-calibration. During this
procedure, the system checks that the laser emission parameters are
correct. We recommend that you check these values using a suitable
external measuring instrument at least every twelve months. If the
measurement readings indicate a wavelength of 970 nm +/- 15 nm, a
power of 0.5 to 5 W or rather up to 7 W after the upgrade and a
resolution of 5% or higher, the calibration is correct.
Select one of three test procedures to check the calibration:
Sirona Dental Systems GmbH
Operating Instructions SIROLaser Xtend
63 18 351 D3576
D3576.201.01.05.02 11.2018