Connecting Cable For Encoder With Endat ® 2.2 - Baumuller b maXX 5000 Series Instruction Handbook Manual

11.1
Cabling
11.1.9.4 Connecting cable for encoder with EnDat
The connecting cable is available as accessory part with M12 or speedtec
Baumüller Nürnberg GmbH.
M12 Follow the instructions below if a self-made cable with M12 is to be used:
1 Utilize the following materials:
2 Fully adjoin the cable shield with the housing of the round connector and with the
Figure 111:
256
Instruction handbook b maXX 5000
Document No.: 5.09021.16
of 328
m Cable: 4x0,38 + 1x(4x0,14)
m High-density D-sub connector: 26-pin, male
m Round connector: 8-pin M12, female (e.g. from Interconnectron)
shielding of the D-sub connector.
Connecting cable for encoder with EnDat
NOTE
The connecting cable must be made according to the figure shown above! 
If there is a different pin assignment, the cable is not functionally operable and could
lead to defects, both in the encoder module and the encoder!
®
2.2
®
2.2 M12
®
M23 from
Baumüller Nürnberg GmbH