7.12
Installation procedure
11 Connect encoders (see
12 Connect the temperature sensor of the motor. (Observe the proper polarity!)
13 Connect the signal generator for the pulse enable:
14 Connect the signal generator for the quick stop:
15 Depends on the application - not for BM53XX - connect a brake resistor (R
16 Connect the motor brake:
142
Instruction handbook b maXX 5000
Document No.: 5.09021.16
of 328
NOTE!
Plugging in and pulling out encoder cables while they are energized is prohibited, and
could lead to their destruction.
Therefore, always first switch off the 24 V supply voltage and lock the plug connectors
in place.
BM53XX via terminals X2 -20 (IF1), X2 -19 (IF2), X2 -12 (M24V)
BM53XX via terminals X2 -13 (SH1), X2 -14 (SH2), X2 -12 (M24V)
terminals Ba+ and Ba-.
BM53XX via the terminals X207 and X208 (option)
ZFront side axis units BM53XX–
as from page 175).
) via the
B
Baumüller Nürnberg GmbH