Mounting; Safety Notes - Baumuller b maXX 5000 Series Instruction Handbook Manual

The device is intended for mounting in a control cabinet.
Mounting comprises the following steps:
1 Mounting preparation 
2 Mounting
6.1

Safety notes

NOTE!
Mounting shall only be performed by employees of the manufacturer or by other qual-
ified personnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m Occupational training or instruction in accordance with the standards of safety en-
(for drilling holes/cutting out sections, see

only with active mains rectifier to operate within C2 surrounding,
for drilling holes of toroidal cores, see
the device (for fixing, see

possibly mounting toroidal cores 
(see ZMounting the toroidal cores–
gineering for the care and use of appropriate safety equipment.
ZDrilling pattern–
ZDrilling pattern toroidal cores–
ZMounting instructions–
as from page 120)
Instruction handbook b maXX 5000
Document No.: 5.09021.16
M
OUNTING
6
as from page 111)
on page 119
on page 113)
107
of 328