Connecting Cable For Encoder With Hiperface - Baumuller b maXX 5000 Series Instruction Handbook Manual

11.1
Cabling

11.1.9.2 Connecting cable for encoder with HIPERFACE

The connecting cable is available as accessory part from Baumüller Nürnberg GmbH.
Follow the instructions below if a self-made cable is to be used:
1 Utilize the following materials:
2 Fully adjoin the cable shield with the housing of the round connector and with the
Figure 109:
254
Instruction handbook b maXX 5000
Document No.: 5.09021.16
of 328
m Cable: Li9YC3x2x0.25-Li9Y3x2x0,25-Li9Y C11Y 1x2x0.34GN. Two cable pairs are
not needed and also not connected.
m High-density D-sub connector: 26-pin, male
m Round connector: 12-pin, female (e.g. from Interconnectron)
shielding of the D-sub connector.
Æ 0.34 mm
2
Æ 0.34 mm
1
4
5
6
7
19
20
17
18
Connecting cable for encoder with HIPERFACE
NOTE
The connecting cable must be made according to the figure shown above! 
If there is a different pin assignment, the cable is not operable and could lead to de-
fects, both in the encoder module and the encoder!
®
.
12
10
8
1
5
6
2
7
3
4
®
Baumüller Nürnberg GmbH