Preparing For Mounting - Baumuller b maXX 5000 Series Instruction Handbook Manual

6.2

Preparing for mounting

6.2 Preparing for mounting
Based on the planning documents and the drilling patterns (see
from page 111), the cutout sections and the positions of the attachment drill holes can be
determined.
NOTICE!
Property damage due to conductive contamination.
Therefore:
m When performing installation work of any kind, it must be ensured that no foreign
m If possible, the drilling of the holes should be done before mounting the device and
CAUTION!
Eye injury due to flung particles.
Metal particles are flung when making the drill holes and the cutout sections.
Therefore:
h Preparing drill holes and cutout sections.
110
Instruction handbook b maXX 5000
Document No.: 5.09021.16
of 328
material (e.g. drill shavings, copper strands, etc.) gets into the device as a result.
the configuring of the cables should take place outside of the control cabinet. If this
is not possible, the device must be appropriately covered.
Remove this covering again prior to start!
Wear protective eye wear!
ZDrilling pattern–
Baumüller Nürnberg GmbH
as