Installation; Safety Notes - Baumuller b maXX 5000 Series Instruction Handbook Manual

This chapter describes the electrical installation of the device. The mechanical mounting
is described in
Initial commissioning is described in the parameter manual 5.09022 in the chapter Com-
missioning.
Prior to installation, ensure that the technical prerequisites have been fulfilled:
1
2 Check the requirements for the electrical cables and the provision of corresponding
3 Check the properties of the connections and the specified configuration of the respec-
7.1

Safety notes

NOTE!
Installation shall only be performed by employees of the manufacturer or by other
qualified personnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m Occupational training or instruction, and the authorization to commission, ground
m Occupational training or instruction, in accordance with the standards of work safe-
ZMounting–
Check the demands on the electrical mains.
cables.
tive cables.
and mark electrical power circuits and devices in accordance with the standards of
the safety engineering.
ty, for the care and use of appropriate safety equipment.
as from page 107.
Instruction handbook b maXX 5000
Document No.: 5.09021.16
I
NSTALLATION
7
123
of 328