Hioki Memory HiCorder MR6000 Instruction Manual page 77

> [Status] > [Save]
2
3
4
1
On the [Condition] screen, configure the
Refer to "1.2 Configuring Measurement Conditions" (p. 5).
2
Set [Media].
3
Set [Recording time].
Enter the recording time.
d 0 to 10000 (days)
h 0 to 23 (hours)
min 0 to 59 (minutes)
s 0 to 59 (seconds)
4
Set [Method].
Set the countermeasure method used if a space of a storage device is insufficient.
Normal Stops the real-time save and measurement if the storage device is full.

Delete Deletes old files and saves files in real time if the storage device is full (waveform files
only).
The instrument deletes files created after the measurement has started; it does not
delete previously existing files.
Setting [Media] to [FTP]
5
Check the input channel settings and other settings, and then start a measurement (by
pressing the START
The data is saved in the storage device in real time during the measurement.
[Realtime save]
forces this setting into [Normal].
key).
and [Sampling] settings.
Saving Data
4
73