Hioki Memory HiCorder MR6000 Instruction Manual page 125

Calculating the existing data
(Loading the data)
Configuring the calculation
settings
Performing the calculation
Displaying the calculation
results
(Evaluating the calculation
results)
(Saving the results)
To specify a waveform scope for calculation
Before execute the calculation, specify the calculation scope with the section cursors on the
waveform screen. Set
screen.
Refer to "2.2 Specifying the Waveform Range (Section Cursor)" (p. 26) and "7.2 Setting
Numerical Calculation" (p. 122).
(To load the measured data to be calculated from a
storage device)
Configure the calculation settings on the
calculation] screen.
Set the evaluation criteria to evaluate the calculation results.
Select [Execute] to execute the calculation.
(To force-quit the calculation, press the
Numerical calculation results are displayed on the
waveform screen.
(Only when the evaluation is enabled)
Save the calculation results as needed.
• To save the results, press the
[Area] to [Segment 1] or
Numerical Calculation Procedure
[Numeric
STOP
key.)
SAVE key .
[Segment 2] on the [Numeric calculation]
(p. 77)
(p. 122)
(p. 132)
(p. 131)
7
121