Configuring The Lan Settings And Connecting To The Network; X84; Configuring The Lan Settings With The Instrument - Hioki Memory HiCorder MR6000 Instruction Manual

Configuring the LAN Settings and Connecting to the Network

9.1 Configuring the LAN Settings and Connecting
to the Network
Before accessing the instrument with a PC using the FTP or an Internet browser, or using command
communication, configure the LAN settings of the instrument and connect the instrument to your
PC with a LAN cable.
Be sure to configure the LAN settings before connecting the instrument to the network. When you
change the settings while the instrument is connected to the network, the IP addresses may not be
unique or invalid address data may be transmitted over the network.
For more information on how to connect the instrument to PCs, refer to "2.6 Connecting the
Instrument with PCs" in Quick Start Manual.
IMPORTANT
Do not change any settings for Windows
Doing so may cause the system operation to become unstable.
Configuring the LAN settings with the instrument
Items to be checked before configuring the LAN settings
The required settings are different depending on whether you are to connect the instrument to an
existing network or establish a new network consisting of only the instrument and a PC.
When connecting the instrument to the existing network
The following items must be assigned in advance by your network administrator. Be sure that there
is no conflict with other devices.
The PC name and address of the instrument
•
PC name (up to 15 characters): ... ____________
IP address: ................................... ___.___.___.___
Subnet mask: ............................... ___.___.___.___
Gateway
•
Whether to use a gateway: .......... Yes/No
IP address (When used): .............. ___.___.___.___
When establishing a new network consisting of a PC and the instrument
(Using the instrument on the local network that does not connect to any external networks)
When no administrator exists for your network or you are entrusted with the settings, the following
addresses are recommended.
Setting example:
IP Address
PC: 192.168.0.1
Recorder 1: 192.168.0.2
Recorder 2: 192.168.0.3 . . . Assign numbers in a sequential order.
↓
PC name..............................Any name (Must be unique)
Subnet mask........................255.255.255.0
Gateway ..............................Off
150
®
other than those described in this manual.
↓