X84; Logic Channels - Hioki Memory HiCorder MR6000 Instruction Manual

Logic channels
The logic sheet is displayed when the screen is in Single, Dual, Quad, Octa, or Hexadeca mode.
> [Channel]
1
Set [Use] to [On] or [Off].
On

Off
2
Set [Logic width].
You can change the display width of the logic waveforms. Making waveforms narrower can enhance the
readability of a display that contains a large number of waveforms.
This setting is shared by all installed logic modules.
Wide
Normal 
Narrow
3
Select a display method for each probe (LA through LD).
Position
Display
Color
Comment
The waveform screen is displayed when a logic channel is
selected. Positions of the logic display can be checked.
Sets the module as the measurement device.
Does not set the module as the measurement device.
Since no data is acquired, nothing can be displayed or saved.
Increases the width of the waveforms.
Displays the waveforms in normal width.
Reduces the width of the waveforms.
Allows you to set the position of the logic waveforms within the display range. The
position of the waveforms can be set in increments of one percent point.
This setting is shared by all probes (LA through LD).
You can move the logic position freely within the screen limits.
Sets whether to display each logic waveform.
Allows you to select a display waveform of each waveform. You can also select the
same color as the lines acquired through other channels.
Allows you to type a comment for each channel.
Number of characters: up to 40
Setting Input Channels
1
1
2
3
17