Hioki Memory HiCorder MR6000 Instruction Manual page 28

Reading Measured Values (Trace Cursors)
7
Tap
[Select cursor]
Every time you tap
by one in sequence. In addition, you can activate any one of the cursors displayed on the screen by tapping it.
Changing the magnification of the waveform display while moving the trace
cursor
Sliding your finger upward on the screen while dragging the trace cursor enlarges the waveform
display centered around the trace cursor in proportion to the dragging distance. Sliding your finger
downward compresses the waveform display.
Once you have adjusted the display to a suitable size, move the trace cursor along the horizontal
axis to change the display position.
Releasing your finger from the screen reverts the display to the original magnification.
To move the trace cursor using the rotary knob X
When [Cursor] is assigned to the rotary knob, you can move the active trace cursor with the rotary
knob X.
If the trace cursor is not displayed on the screen even though it is enabled
Check the position of the trace cursor on the scroll bar. (p. 31)
24
.
[Select cursor]
when the multiple trace cursors are displayed, a cursor is activated one