Hioki Memory HiCorder MR6000 Instruction Manual page 20

Setting Input Channels
6
Set [Display].
On  Displays the waveforms on the waveform screen.
Color
Invert
(Off  , On)
Vernier
Off Displays no waveforms.
7
Set [Scaling].
Refer to "3.2 Converting Input Values (Scaling Function)" (p. 42).
8
Switch the channels.
Tap the corresponding location to switch the channels.
9
Set [Digital filter]
The [Df] setting is displayed for only channels with
filter for each channel.
For more information, refer to "Setting the Digital Filter Calculation" in Calculation Guide.
16
Allows you to select display colors of the waveforms. You can also select the
same color as the lines acquired through other channels.
When the signs of displayed waveforms are reversed, the waveforms can be
inverted.
Refer to "3.4 Inverting the Waveform (Invert Function)" (p. 49).
Allows you to fine-adjust the input voltage freely on the waveform screen
(display adjustment only). When recording physical values such as noise,
temperature, and acceleration with sensors, you can adjust those amplitudes,
facilitating calibration.
Refer to "3.3 Fine-Adjusting Input Values (Vernier Function)" (p. 48).
for each channel. (Model MR6000-01 only)
[Digital filter] set to [On], allowing you to set the digital