Hioki Memory HiCorder MR6000 Instruction Manual page 8

Measurement Procedure
To perform the automatic setup
On the waveform screen, tap
position of input waveforms automatically, and then start a measurement.
Refer to "3.7 Measurement With the Auto-range Setting" in Quick Start Manual.
To load settings registered previously
Load the settings file on the file screen.
Refer to "4.3 Loading Data" (p. 77).
To load saved settings automatically at the time of startup
Configure the setting for the instrument so as to load the file containing the instrument settings at
the time of startup.
Refer to "Loading the settings automatically (Auto-setup function)" (p. 78)
To initialize the instrument (restoring the basic settings)
Restore the instrument settings to the factory default by tapping [Initialize], which is accessible by
proceeding in the following order:
[System]
>
The setting after the initialization is suitable for simple measurement.
If any unexpected or complicated behavior is observed, initialize the instrument.
Refer to "6.2 Initializing the Instrument" in Quick Start Manual.
4
[Auto range]
[Initialize]
>
to set the sampling rate, measurement range, and zero