Table of Contents
Advertisement
AMT58x-PN ProfiNET®
Then configure the IO device and set its port 1 to be connected to the
port 2 of the IO controller. Double click the X1 P1 PORT 1 slot in the
Device configuration table and open the Port 1 properties dialog box.
The Properties – Interface – Port 1 property sheet will appear.
Enter the Topology tabbed page and set the Port 2 (X2 P2 R) value
in the drop-down menu in the Partner port item of the Partners group
box. Confirm pressing the OK button.
Refer also to section "11.7 Topology Editor".
Figure 44 - Configuring the IO device topology
82
Advertisement
Table of Contents
